Pro-series 51089 51 Receiver Bedienungsanleitung PDF herunterladen

Installation Instructions

DODGE NITRO

Part Numbers:

51089

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 18mm, 19mm

Drill Bits: NONE

Hitch requires 5/8” pin & clip

1. Remove bolt from driver’s side vehicle support bracket and return to vehicle owner.

2. Raise hitch into position.

Note: For vehicles equipped with a full size spare tire, it may be necessary to temporarily lower spare tire.

3. Position hitch between frame & support bracket (driver’s side) and loosely install the six M12 bolts and conical toothed

washers as shown.

4. Tighten all fasteners to 75 Lb-Ft (102 N*M).

5. Raise spare tire if lowered in step 2.

Rev. A10-9-0751089NSheet 1 of 3

z 2007 Cequent Towing Products

Conical Toothed Washer 1/2Qty. (6)

M12 X 1.75 X 40mm CL 8.8 Hex BoltQty. (6)

Tighten all M12 CL 8.8 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 51089F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

500 (227 Kg)5000 (2268 Kg)

Weight Carrying

Ball Mount

600 (272 Kg)6000 (2721 Kg)

Weight Distributing

Max Tongue

WT (LB)

Max Gross

Trailer WT (LB)

Hitch type

Wiring Access Location: SUV 1 & 2

Form: F205 Rev A 5-6-05

Weldnuts – 3 places

Both sides

Vehicle Support

Bracket

1 2 3

Inhaltsverzeichnis

Seite 1 - Installation Instructions

Installation InstructionsDODGE NITROPart Numbers:51089Hitch Shown In Proper PositionEquipment Required:Wrenches: 18mm, 19mmDrill Bits: NONEHitch requi

Seite 2 - Instructions d’installation

Instructions d’installationDODGE NITRONuméros de pièces :51089Attelage montré dans la position appropriéeÉquipement requis :Clés : 18 mm, 19 mmMèches

Seite 3 - Instrucciones de instalación

Instrucciones de instalaciónDODGE NITRONúmeros de partes:51089El enganche se muestra en la posición correctaEquipo necesario:Llaves: 18mm, 19mmBrocas